• IP20 independent driver, for indoor
   use
• Multiple LED driver
• Supplied with dip-switch for current
   output selection
• Active power factor corrector
• Light regulation 0-100% by means of    PUSH function (L mains voltage:    170kohm):
- a short push to turn ON/OFF
- a longer push to increase/decrease light    intensity
- regulation automatically stops at minimum    and maximum values
- For another on, regulation or off    command release the button the push    button and give the desired command    again
• Maximum length of cable, from push    button to last driver, must be max. 15m.    In case ofapplications where the cable is    longer than 15m, keep this separate from    the 110-240V mains cable
• 1.5m synchronisation cable is separately    supplied    (Code:485720512)
• Maximum 10 drivers in series, controlled    by one or more PUSH buttons

IMPORTANT: only use normally open push buttons with no incorporated warning light.

• Light regulation 0-100% bymeans of    PUSH function, 1...10V interface    (1=0.35mA) or 100 Kohm potentiometer
• Class II Protection against electric shock,    following direct /indirect    contact
• Current regulation +/- 5% including    temperature variations
• Supplied with terminal cover and    clamping screws
• Input output terminals on the same side    (max. wire cross-section =    1.5mm2)
• Clamping screws on primary and    secondary circuits for cables with    diameter: min. 3mm - max. 8mm.
• The driver can be secured by means of    threaded slots.
• Protections:
- against overheating and short circuits
- against mains voltage spikes
- against overloads
• Possibility of ignition and power off on the    secondary for current LED (power LED)
• Suitable for the supply of power LED and    LED modules